Accessing VOXL 2 on IF800

  1. unscrew bottom cover using a T8 torx driver

  2. the bottom cover can dangle, you just need to remove these 5 screws with a 2.5mm hex driver once the cover is pulled off:

  3. after those are off, flip over and take off the top cover screws with 2.5mm hex driver (its also fine for this to stay attached, can rotate it 90 degrees and rest it on top of the drone once its off)

  4. then take off these torx screws with a T8 driver

PreviousSSH into VOXL2 on IF800NextHardware Connection VOXL 2

Last updated